Pilot holes are typically the first holes drilled in any assembly. They are usually too small to accommodate the shank of any standard fastener, so they must be enlarged before fasteners can be installed in the assembly.
Estimated completion time (hours): 1.1
By the end of this course, you will be able to do the following:
- Create a drill start with a drill motor and pilot bit
- Drill a pilot hole
- Exchange a pilot bit for a larger drill bit
- Set a drill stop
- Enlarge a hole to size
- Inspect a full size hole using a Go/NoGo pin gauge
Estimated Time (Hrs): 1.1
Language: English