Before the fasteners can be installed in this assembly, the assembly must be constructed and the holes prepared.
Estimated completion time (hours): 1.6
Objectives
By the end of this course, you will be able to do the following:
- Recognize fastener location and identification information on an engineering drawing
- Explain where to find the tools, fasteners, and other supplies needed to create the assembly
- Mark fastener locations on the assembly
- Drill pilot holes in the assembly
- Enlarge the pilot holes to size
- Chamfer the holes in the assembly
- Take the assembly apart
- Deburr holes in the assembly
Estimated Time (Hrs): 1.6
Language: English